Laxmi Infrastructure

HYDROSTOP 3PY-P is APP Polymer Modified Bituminous Waterproofing Membrane Sheet of 3mm Thickness. Composed of Non-Woven Polyester Mat as Core Reinforcing Media suitably finished with Thermo Fusible Polyethylene Film on top and bottom side of sheet. Application: Torch-on Method Membrane Size: 1m x 10m Rolls Top Finish: Plain – Thermo Fusible Polyethylene Film Bottom Finish: Plain – Thermo Fusible Polyethylene Film

HYDROSTOP 3PY-P is APP Polymer Modified Bituminous Waterproofing Membrane Sheet of 3mm Thickness.
Composed of Non-Woven Polyester Mat as Core Reinforcing Media suitably finished with Thermo Fusible Polyethylene Film on top and bottom side of sheet.
Application:- Torch-on Method Membrane Size: 1m x 10m Rolls Top Finish: Plain – Thermo Fusible Polyethylene Film Bottom Finish: Plain – Thermo Fusible Polyethylene Film TECHNICAL DATA ADDITIONAL TECHNICAL DATA *Tolerance:- Thickness: - ±10%, Longitudinal Tensile Strength: ± 200 N/5cm, Transversal Tensile Strength: ± 150 N/5cm, Elongation at Break: ± 15%, ^ Compound Properties Tested During Manufacturing Process Note: The results given are laboratory test results of manufactured samples. Results derived from field applied samples may vary. Properties Typical Values Unit Test Standard Properties Typical Values Unit Test Standard Nominal Thickness* 3.0 mm ASTM D 5147 Penetration @ 25º C <20 dmm ASTM D 5 Softening Point^ >150 ºC ASTM D 36 Properties Typi

DESCRIPTION  DANOCRET  I PROTECT  FLEX  is  a  two  component  acrylic  polymer  modified  cementitious  flexible  waterproofing membrane coating  for waterproofing  and protection of cementitious surfaces.   It  consists  of  specially  graded  cementitious  powder  as  Component A  and  liquid  Acrylic  co polymer  as  Component B  in  pre pack  form,  requiring  mixing  of  both  the  components  in  proportion  at  site  and  application  using  stiff  bristle  brush  to  required  thickness in two coats.

Additional Information:

• Delivery Time: 9.00AM TO 6.00 PM

DESCRIPTION TIKI PRIME S is a Ready to use Single Component Quick Drying Low Viscosity Primer in Liquid Form. It is prepared using Special Grade Bitumen under Controlled Condition in Refined Solvent. USES It is used as Primer on Concrete, Masonry, Metal, Asbestos Sheet, Wood and Stone Surfaces for Sealing Substrate Pores and Promote Adhesion of Bitumen Based Waterproofing Systems, whether Liquid, Felts or Membranes with the Substrate.

Additional Information:

• Delivery Time: 9.00Am - 6.00 Pm